What are some other areas to utilize FloorPops Peel & Stick tiles? Then after 5 days, I removed the tape and it was all fine. We did have a couple of tiles fall off initially on the install day, so we used masking tape to tape the edges together on the bottom row specifically, over the tiles.Wait until 5 days after installation to do any cleaning to the tiles so the adhesive has a chance to set.Make sure to watch the video in this Amazon listing for how to easily install FloorPop tiles and follow their directions.Once you get going, you’ll be able to cut several pieces the same size in a row to make it go faster.Ĭutting around the electrical outlets is a little bit of a hassle, but if you measure and trace around where the outlet goes and cut that area off of the tile, you’ll then able to stick on the tile and put the outlet cover back on easily. You’ll first need to determine the size tile you’ll need cut, mark it using a marker or pen that can be wiped off, and make your cut. We used a sharp utility knife and the edge of a metal leveling tool to make straight cuts. Making the cuts around the side bottom rows was the most time-consuming part. We started in the middle on the top, so that the seam for the last row was right at the bottom. Well, basically it’s a giant vinyl sticker! So after cleaning the walls first and letting them dry, we stuck them on the wall making sure to place them right next to each other evenly. Hip Tip: If this black and white pattern doesn’t suit your style, make sure to check out all their other designs! This means we are now technically installing these tiles over a couple of large pieces of smooth thin plywood, not directly over the textured wall. Important Disclaimer: It’s also worth noting that before painting the chalkboard wall years ago, we first nailed down a piece of super thin 1/4 inch plywood, so it would be a smooth surface and not a textured wall. Over time I noticed the chalkboard paint needed to be repainted and decided it would be fun to change things up a bit. Later on, we had the top of the wall tiled with subway tiles and it looked great together with the contrasting black and white. It was time for a change on this feature wall.Ībout six years ago, I painted the bottom of my kitchen wall using black chalkboard paint and have loved it. The best part is that there were no trips to the hardware store at all, and we were able to get this wall done in under 3 hours for just $50! We installed these stylish vinyl tiles recently in our kitchen as an easy DIY project and I’m super impressed with the results! Screws will do a good job though.Want to easily add some custom style to your home on a small budget?Ĭonsider using these fun and decorative FloorPops Peel & Stick tiles to beautify your home. What do you guys recommend? The hardie board seems smoother, easier to cut and less dust. What do you think for cement board? Seeing many types. So goes like this top to bottom:ġ) Ecodeck wide temperature vinyl (adhesive and hot air weld)Ģ) cement board (screws and quickset, including a skim coat)ģ) tapered insulation board (large washers and screws) Cement board is needed because the Grace Ice & Water barrier and Vinyl are x2 water barriers and can't place plywood between them. What's next is pitched rigid insulation (1.5in to 0.5 inch at the drain, 1.5in everywhere else), then cement board for the vinyl. We already have Grace Ice & Water barrier over the 3/4" PT plywood floor. We decided on wide temperature vinyl by Econodek for the flooring. We have a geodesic greenhouse with 530 sqft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |